Port Forwarding Q

General help and assistance forum.
Post Reply
Maximus
Registered just to make one post
Posts: 1
Joined: Sat Dec 09, 2017 5:20 pm
Clan: X
Clan Tag: [X]

Port Forwarding Q

#1

Post by Maximus » Sun Dec 10, 2017 6:25 pm

sweet and simple
im trying to make servers on a pc at my work. it is sharing a router with 2 other computers. I log into my modem ip, and i enable port forwarding, use this computers ip, and ipv6. start port 10666, end 10700. i still recieve this message:
NAT discovery error: Fail to find an UPNP NAT.

i enabled upnp. if screenshots would help, i can provide them. thanks.

User avatar
Sean
IRC Operator
Posts: 909
Joined: Thu Jan 16, 2014 9:09 pm
Location: England
Clan Tag: [TSPG]
Contact:

Re: Port Forwarding Q

#2

Post by Sean » Mon Dec 11, 2017 6:31 pm

Maximus wrote:
Sun Dec 10, 2017 6:25 pm
ipv6
Unfortunately, Zandronum doesn't support IPv6 so you need to use your computer's IPv4 address instead.
<capodecima> i dont say any more word without my loyer jenova

Post Reply